Live SupportMon-Fri 8am-6pm Est

1-888-368-5461

 

  • My Cart

    Your cart is empty

    You have no items in your shopping cart.

Tips for Working in a Construction Grid

construction grid

Working along a control line requires knowing the distance between the defining point A and the target P. To orient the theodolite, you’ll need a second point to position the telescope before measuring the distance.

The given line and the distance between P and A define the point P. In case P is not on the line, in addition to the above, the perpendicularly measured offset between the line and P is needed.

Distance along the line and offset are both needed to define the construction gridDistance along the line and offset are both needed to define P. Both values are often referred to as “line and offset” or “chainage and offset.” The line starting at A and its perpendicular line given the direction to P define a so-called grid.

Instead of line and offset, P can be defined with the angle Hz between the line and the direction (left or right of the control line), plus the distance between the instrument and P. These are so-called “polar coordinates,” often used by surveyors.

Working With Northing and Easting

easting and northing values can also be used to define a pointIf there is no preferred control line available, a situation that often occurs in road construction, easting and northing values can also be used to define a point. Surveyors call these “local coordinates.”

Similar to the line and offset used in the grid above, you need two values to define a point position. In special cases, the northing and easting values match the official country mapping datum. 

Calculating Point Elevation

To measure the absolute height of point P, you must know the height of the tilting axis of the telescope. The height of the tilting axis is the elevation of the station point Hs plus the height of the instrument setup (=hi).

Next, to compute the elevation of P, the height of the reflector (typically denoted as hr) must be known as well. The instrument further determines the height difference dh between the reflector and tilting axis of the instrument out of the measured zenith angle and the distance measured. Finally, the height of point P can be computed as: Height of P = Hs + hi – hr + dh.

Calculating point elevation